5/29/2023 0 Comments Proselect psts11p52These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. This device must accept any interference received, including interference that may cause undesired operation.Ĭhanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.įCC Interference Statement (Part 15.105 (b)) (USA only).This device may not cause harmful interference, and.Operation is subject to the following two conditions: This device complies with Part 15 of the FCC Rules. Gateway is Registered to Regulatory information FCC Compliance Statement (Part 15.19) (USA only).Gateway is Connected to the RedLINK system.Red: The RedLINK Internet Gateway is not communicating with the RedLINK system.Green: The Gateway is connected to the RedLINK system.Green (flashing): The Gateway is connecting to the RedLINK system.Off: The Gateway is not connected to the RedLINK system.The Internet LED will be amber during this time. If there is a continuous ping error to the servers, RIG will release the IP and capture it again.RIG will work with the server it can reach, but will regularly ping servers that didn't give a response to see if the connection is restored.RIG will flash red at 1Hz if it cannot ping all servers.If at least one can be reached, the Internet LED will be solid green. If there is no response, then the ping action failed. The RIG waits for up to 15 seconds for a response. The RedLINK Internet Gateway (RIG) pings a specific server approximately every 5 seconds. Solid Amber: Ethernet Connection Detected (cable connected and Gateway is retrieving the IP address).Solid Red: No Ethernet Connection (cable disconnected or Ethernet connection error).LED Behavior Power LED Solid Green: The Gateway is powered Provide company business card so that the homeowner can enter your contact information.Log in and register the gateway at by entering the MAC ID and MAC CRC found on the bottom of the device.Step 6 Instruct the homeowner on the account set up and registration process.Step 5 Press and release the CONNECT button on the side of the RedLINK internet gateway.Step 4 Enter the WIRELESS SETUP MODE on your thermostat (refer to thermostat instructions).Step 3 Connect an Ethernet cable from the RedLINK internet gateway to an internet-connected home router.Step 2 Connect the power adapter to a wall socket.Step 1 Connect the power cable to the RedLINK internet gateway.If the thermostat is linked to an HZ322 or HZ432 zone panel with a THM4000R wireless adaptor, then the zone panel is the host (up to 3 thermostats per HZ322 and up to 4 thermostats per HZ432).įor assistance with this product please visit or call Resideo Customer Care toll-free at 1-855-Red-Link (85).If the thermostat uses an EIM (Equipment Interface Module), then the EIM is the host (one thermostat per EIM).A thermostat that is wired to the heating/cooling equipment, or to a zone on a zone panel.Maximum Number of Hosts: 4 per RedLINK Internet Gateway. ![]() Power Adapter Output Voltage Range: 4.80 VDC ~ 5.20 VDC.Power Adapter Rated Input Voltage: 100 VAC ~ 240 VAC 50 Hz/60 Hz.Operating Relative Humidity: 5% to 95% (non-condensing).Failure to follow these instructions can damage the product or cause a hazardous condition. Must be installed by a trained, experienced technician. The RedLINK Internet Gateway provides remote access to RedLINK thermostats through the internet and smart phones. Honeywell THM6000R7001 RedLINK Internet Gateway Read before installing ![]()
0 Comments
Leave a Reply. |